make simple drip water tower procedure text

                                                 How to make simple drip water tower


How to make simple drip water tower

tools and materials
·    
           Plastic bottle of water beverage packaging size of 500 ml or 1500 ml,
·         cutting tools (scissors, knives),
·         nails,
·         glue
·         straws and pipes,
·         rubber flip-flops.
·         castol glue, c
·         utting tools and
·         paper insulation.

he way in making this tool is as follows:

1. Prepare all the tools and materials that have been written above.
2. Cut the bottom / butt the beverage bottle 10 cm from the bottom.
3. Drill cover the beverage bottle using a straw-size nails (nail should be preheated).
4. Enter a cigarette filter straw into the hole along the cigarette filter size (try not to loose).
5. Insert a straw that has been filled with filter cigarettes into the hole cover bottle (which was included was a hole that no filter is 10 cm long).
6. Once the straw is inserted into the hole cover bottle, seal with a rubber slipper under the cover of the bottle to prevent leakage (rubber slippers and cover the bottom of the bottle should be used with glue smeared castol).
7. Close the back of the bottle with the lid tightly and basting again with glue pipe.
8. Cut the gauze and a bottle cap that had been cut with gauze and tied with a rope to tight (gauze serves to filter out impurities in the water so it does not clog the surface of the filter).
9. holes in the side of the bottle top to place a rope.
10.Ikat bottle on bamboo / wood as a pole.
11.Tancapkan these tools fit in the next crop.
12.Masukan water to the brim, and the appliance can be used. This tool has 10 seconds once the water pressure drops. If you want to turn it into a longer eg 20 seconds then we just add another cigarette filter throughout the filter size (meaning there are two pieces of filter cigarettes in the straw hole).